Disk separator

Appointment

The disk separator is designed for sorting bulk materials: to separate large foreign objects (stones, etc.) and too large a fraction of raw materials (coarse waste, bark, humpback, scraps, etc.) from raw materials at the raw material acceptance site. Thanks to the self-cleaning design, it is able to work with almost any material.

Characteristic

The separator consists of a frame and disc shafts, the torque to which is transmitted through a gear motor. The adjacent shafts are rotated by a chain drive. The discs are removable, the disc spacing is determined by the length of the bushings between adjacent discs of the same shaft.

The type of separated material is wood chips, sawdust, bark of natural moisture with a rare inclusion of coarse waste.

The size of the particles produced at the outlet and the performance depend on the disc spacing of the separator. Increased productivity is achieved by increasing the number of shafts and the width of the separator.

SD-9

SD-7

SD-5

The disk separator is equipped with:

• A gear motor.
• A receiver for raw materials.
• Additional equipment.

The principle of operation

The raw material is fed to the disc separator from above. The required fraction of raw materials passes through the gaps between the rotating discs and is unloaded from below, and the non-required fraction of raw materials and foreign objects do not pass through the discs and, due to the rotation of the discs, move along the surface to the place of unloading. The size of the particles produced at the outlet and the performance depend on the separator disc spacing, the number of shafts and the width of the separator.

Advantages

• Self-cleaning.
• High performance.
• Removing a bearing assembly or shaft without removing other bearings and shafts.
• Easy installation.